Much has been written over the last couple of years about
saddle slippage. There has been excellent work undertaken by Sue Dyson,
MA, VetMD, PhDDEO FRCVS and her team at The Animal Health Trust. The
conclusions seem to have been understood as ‘if a saddle slips over to one
side, there is almost certainly an underlying lameness'.
Master Saddler and Master Saddler Fitter Kay Hastilow
sheds more light on the discussions ...
All well and good, but let’s just think about this. I have
been told by several eminent veterinarians that very few horses are truly one
hundred percent sound. Certainly, in my 50 years as a saddler I have found this
to be true. Most horses on a run-up or when ridden may show a slight asymmetry
of pace, length of stride, elevation of each limb or straightness of movement.
This is why saddle fitters should watch the horse move. Not so that we can
‘condemn’ the horse as being lame, but to note and bear in mind these slight
abnormalities as they would impact on the way that the saddle fits.
However, there are many other reasons why a saddle can move
off to one side. Let’s consider a few of these.
Of course, the saddle might not be straight. ‘Twisted ’
trees are actually quite uncommon, but panels are often not in straight or
level, either at the front or at the back. You can often see that when you look
from the underside through the panel that it is not in line with the centre and
side rails of the tree. In this case, of course the saddle will sit to one
side. The flocking may not be even both sides, or not corresponding to the
shape of the back. Uneven girth straps and webs can alter the way a saddle
sits. There are many different reasons why the saddle won’t sit straight to
start with.
Many horses are asymmetric in the shoulders. It may be that
one is higher than the other, more pronounced, or one is set further back than
on the opposite side. This is generally skeletal and cannot be altered by
working the horse in a certain way. If the saddle is placed a little too
forward, this will push the saddle over to one side at the back. In actual
fact, if I could just get people to realise that most of them put the saddle
too far forward and get them to set it just a little further back, many of the
fitting problems that we see would disappear overnight!
It may be that the shoulders are even, but development
behind here is uneven. Often, horses have not built up so much on one side as
the other. Usually, but not always, it is the left (near) side that is less
developed and there are many theories as to why this should be so. Obviously,
if there is less development on the left, the saddle will drop into this hollow
and sit to the right at the front. Many feel that they want to lift the right
front to balance it, but it is almost always the left front that you would add
to in this case, either with shims or flock. What action the saddler would take
would depend on the age of the horse, the time in his present ownership and the
work he is doing. If it is a young horse in a new home where he will be worked
well by a good rider, there is a good chance that the muscle can be built up on
this side, but an older horse who mainly hacks out, with the rider almost
always rising on the same diagonal at trot and allowing the horse to lead on
his favoured leg in canter is unlikely to change, and so the best solution would
be to add flock to the opposite side to the way the saddle moves.
Muscle development right through a horse’s back can be
unlevel side to side (this is probably a result of a slight lameness, but the
result is that the saddle moves) You may wonder why your saddle fitter
takes a good look at your horse’s conformation, does a ‘back assessment’ and
watches him move. It is to find these facts out so that they, and through them
you, are aware of any potential difficulties that may arise with the fitting. If
your saddle fitter doesn’t do these assessments and just comes in and starts
putting saddles on, I would question his or her ability. I call these people
saddle sellers, not fitters, as recognising differences such as those mentioned
above and their likely influence are essential to be able to achieve a
satisfactory fit.
Having seen the effect such conformational or development
factors can have on the fit, let’s consider the rider. The rider that is
straight and balanced is a rarity. Even those that look okay are seen to be
slightly ‘squint’ when filmed wearing the Visualise’ jacket from Centaur
Biomechanics. This excellent tool has stripes of fluorescent tape strategically
placed on the front, back and sleeves. You can see how straight the rider is
with the naked eye, but you can see more clearly when you film the rider from
the front, back and side. You can replay and freeze frame where you are not
sure. The deviation from straight and centre can be slight or marked, and can
really affect the way a saddle sits. Of course, if a ‘squint’ rider uses a
saddle for a while, that will alter it so that it will move to one side even
when others ride in it.
Take a look at yourself. If you ride down a straight road
and a friend films from behind, you will see just how straight you are sitting.
You might be in for a shock!! You would be surprised, I think, to find out how
many people ride with uneven length stirrup leathers, either by design or
ignorance, and many riders will have far more weight in one foot than the
other. Try this. As you are riding along, half close your eyes. (Make sure that
you are somewhere safe when you do this!) Think about the weight in the
stirrups. I bet one has much more weight in it than the other.
Hands and shoulders are another influence. Rein gauges used
in testing have shown that very few riders have an even contact with their
horse’s mouth. Add to that many ride with one shoulder higher or more forward
then the other, and the imbalance can send everything off centre as the horse
tries to cope with this.
A rider's legs are another problem. It is not uncommon for a
rider to have one leg further forward than the other, with the knee sitting
more forward or higher in the knee grip on this side. The lower leg may or may
not be in the same position both sides, and the hips and seat of the rider are
rarely completely square. All of these ‘rider faults’ can take the saddle over
to one side, or unbalance the horse, so that in his effort to keep balanced he
moves the saddle.
Dealing with the above problems are everyday occurrences for
saddle fitters. Is the problem solvable? Can the rider straighten out? Is a
trip to the physio for both horse and rider necessary? It’s no point
straightening one half of the equation if the other half is still squint - and
any changes made to either will take time to bed in.
If it is something that is not going to be solved by
training or treatment, there are many things that the saddle fitter can do to
hold the saddle straight. The addition of an extra girth strap in the correct
position, adjustment to the flocking in the saddle or the use of shims and
other work can correct the saddle slip, and remember, whilst we would all like
our horses and their riders to be completely straight and square, this is
unlikely to happen. It is also unlikely to improve while the saddle is drifting
off to one side, as the muscle will not re-build whilst there is excess
pressure to that area. The saddle needs to be straight for this to happen.
The first video in Kay Hastilow's Saddle Fitting
Know How For Riders and Trainers looks at conformation and its influence on
saddle fitting, the movement of the horse, the different types of saddle trees,
panel types, positioning of girth straps and how they can all influence a fit.
The second video explains how a trained and qualified
saddle fitter will assess a saddle for straightness, soundness and safety,
along with static and dynamic recognition of a good fit and how the balance of
the saddle influences the rider. It also explores why saddles move to one side
and looks at the influence of the rider.
Available to stream and download anytime, each video costs
less than the price of a good quality saddlecloth at just £35.
No comments:
Post a Comment